DCS Path Replacement

[BuckWeet]

I have a DCS+ network using ISDN and i'm trying to get path replacement to work. It works (at least it seams to) when I do call forwarding, but whenever I try to get it to replace the path when doing voicemail its always tieing up 2 trunks..

I've read the networking guide, dcs sup service E is in use, the SBA held at principal is turned off... TSC's are up and active..

Any other ideas??

FYI these are IP trunks too.

Thanks

BuckWeet

 

[BuckWeet]

These switches are r9.5.. Does r9.5 not support reroute on IP trunks??

I have the exact same setup on CM 1.3 systems and it works fine..


Thoughts?

BuckWeet

 

[VOIPeng]

Did you get this working, if you did what did you need to setup?

We set up the Qsig Path Replacement Extension, on the trunk group we have Better-route selected and it is setup as Protocol B, on the second page of the Trunk Group do we need the NCA-TCA Trunk member defined?


Thank you,
VOIPEng

 

[george630us]

We had a similiar problem. It ended up that the "Data restiction" field on the analog ports to the Intuity had to be set to No.