DAY/NIGHT MODE CHANGING

[pea123]

Hie to you all.

Was wondering how one can change from Night Mode to Day Mode on Mxe 3300 were there is NO Attendant Console.

Help.

 

[sarond]

You program the feature access code and allow a phone to be able to use Dialled Night Service in their COS.
Then to you use it you would dial, FAC+(0-2)
0=Day
1=Night1
2=Night2
In the later releases (From MCD 5.0 I think) you can also program a Night Service Indicator key so that you can visually tell if you are in Day/Night. Although it doesn't tell you what night you're in until you press the key.

 

[LoopyLou]

ALso can be scheduled in the newer software.

The beatings will continue until morale improves.

 

[james1982]

sure you can also activate this on older releases (pre MCD6 with the schedule via maintenance commands:-

PROGRAMMED SERVICE SCHEDULE NIGHT1 DAILY <hh:mm:ss>

PROGRAMMED SERVICE SCHEDULE NIGHT1 ON/OFF

PROGRAMMED SERVICE SCHEDULE NIGHT2 DAILY <hh:mm:ss>

PROGRAMMED SERVICE SCHEDULE NIGHT2 ON/OFF

PROGRAMMED SERVICE SCHEDULE DAY DAILY <hh:mm:ss>

PROGRAMMED SERVICE SCHEDULE DAY ON/OFF

PROGRAMMED SERVICE SCHEDULE ON/OFF

PROGRAMMED SERVICE DISPLAY

 

[Supernova99]

You can also do it from the maintenance command CP SERVICE DAY, NIGHT1, NIGHT2 & DISPLAY

Share what you know - Learn what you don't

 

[pea123]

Thank you all for your helpful responses.

 

[kwbMitel]

I miss the good ol days when if you wanted scheduled night service you needed to setup a modem on a computer to dail the digits at a set time.

Then again...

**********************************************
What's most important is that you realise ... There is no spoon.