Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Data Migration Log source disk info?

Status
Not open for further replies.

ARCserveAdmin

Technical User
Jun 21, 2010
13
US
Havn't found anything on this in the documentation so am looking for some confirmation if possible. In the job logs on our Data Migration logs each session has the source shown as C:. However, the actual data is being copied from a different device. As the job detail log shows. Here is a sample of what is shown in the Source Targets:

C$\BACK01_O_DD;53326;1;BACK01_O;5;0\BACK01_O_DD;1277681376;13199;131200;3470;180405

Now I am thinking that the reason why the log shows the C: drive is because of the C$ that begins the source line. Even though this is not the actual device that is being migrated. Does this seem correct? TIA

Craig
 
here are a couple of CA Technologies related to the subject.

What is the data shown under Source Targets for a Migration Job, Job Detail? TEC525816

How to determine the last session migrated. TEC525816
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top