D250 to NI2 protocol

[trvlr1]

1000E 5.0
We are about to swap out LD PRI circuits in the near future. During this change we have to go from D250 to NI2 Protocol. Other than the IFC promps in the RDB and the Dchan is there anywhere else changes need to be made?

 

[johnpoole]

no, if everything else stays the same you just have to change the IFC.. you do have to out the trunks, then the route, then the d. put them back in with the new ifc.. reload the msdl.. then enable the loop.

in 14 you can out 23 and new 23 so the complete process takes under 15 minutes..

john poole
bellsouth business
columbia,sc

 

[BMiles2000]

One would think a simple change of the prompts... but John is correct... out... rebuild... download... enable...

Bryan J Miles
Systems Engineer
Service Communications, Inc.

http://www.servicecommunications.com

 

[trvlr1]

Thanks guys, yes I knew about the rebuild, but something in the back of my mind was bugging me that there was something else ..... good to have things confirmed though, thanks for your replies!