D100 setup??

[BobbR]

Legend R7, three D100 modules to tie three slave Legends to this one Master. Slot 12 apparently defaulted to Rob_Bit, as below. How can I change this? Slots 5 and 11 are hardwired, Slot 12 is connected via Paradyne CSUs and T1. This unit was DMI-MOS before installing a D100 in Slot 5 and reprogramming, came up now as shown:

DS1 SLOT ATTRIBUTES
Slot Type Format Supp Signal LineComp
5 PRI ESF B8ZS DMI-MOS 1
11 PRI ESF B8ZS DMI-MOS 1
12 PRI ESF B8ZS Rob_Bit 1

 

[franke]

hmm, wierd. Do you have any other trunk modules installed (i.e. 408 mlx, etc)? Did the D chan get assigned somewhere (b chan grp, trunk grp)? just for giggles, did u try changing it from robbed bit to common channel?

franke

 

[BobbR]

Franke,
I tried selecting Common Channel but to no avail, appeared to be selected but no change in printout. So, I set to T1 which wiped out info, then changed back to PRI and entered my parameters (actually, the correct settings were highlighted but I hit <enter> anyway. It magically went to DMI-MOS. Thanks for suggestions.