robakabobbo
Technical User
I totally forgot the password, How to I factory reset this phone. I did a hold of the maintenance mode with the register button. I cant get into this thing. Any advice?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
D100 Reset
- Thread starter robakabobbo
- Start date
- Status
teletechman
Technical User
Take a look at this page from the knowledgebase.
or
Resetting the base station using the base station
Only use this method to reset the base station to factory default when the preferred and alternative methods fail. See Resetting the base station using before you attempt the following method.
Procedure
Press and hold the Registration button located on the front of the base station and insert a pin into the Reset button hole also located on the front of the base station. Hold both buttons for five seconds.
The base station resets the following parameters to the default values indicated:
IP Address: 192.168.1.100
Subnet Mask: 255.255.0
Default Gateway: 192.168.1.1
You can now use the Base Station Web Management Interface to reset the base station
Mike
or
Resetting the base station using the base station
Only use this method to reset the base station to factory default when the preferred and alternative methods fail. See Resetting the base station using before you attempt the following method.
Procedure
Press and hold the Registration button located on the front of the base station and insert a pin into the Reset button hole also located on the front of the base station. Hold both buttons for five seconds.
The base station resets the following parameters to the default values indicated:
IP Address: 192.168.1.100
Subnet Mask: 255.255.0
Default Gateway: 192.168.1.1
You can now use the Base Station Web Management Interface to reset the base station
Mike
- Status