Cxi Relay Question

[steveycarr]

Hi Guys,

Does anyone know if I can use either the Relay or PA Relay contacts output to operate a door entry system. If so how do you operate the relay, for the external paging/loadspeaker the feature code suggestion is **9 and setting the COS to allow paging all zones, I've done that but I cant dial the code, I get a "Not Allowed" which looks like COS, have I missed something in the COS or am I looking to achieve soemthing that cant be done?

Thanks in advance

Steve

 

[SXWizard]

You do't say what controller but I assume it's a 3300. The Relay is not used (reserved for future use). You need to do the following programming. I think you missed the E&M setting:
Programming

Loudspeaker Paging is provided through the Paging port on the Universal ASU, Analog Main Board, or Analog Options Board. This Loudspeaker Paging port emulates E&M paging. A Loudspeaker Pager (amplifier) connects to this port.
For E&M type paging, program the Zone Number and Interconnect Number in the Loudspeaker Paging Assignment form. In multiple-zone systems, all-zone paging must be designated 00 whether all-zone paging is enabled or not.
Ensure that the station is not restricted from Paging in the Interconnect Restriction Table.
Enable Pager Access All Zones and/or Pager Access Individual Zones in the Class of Service Options Assignment form.
If you intend to use a feature access code in Operation, assign a code to Loudspeaker Paging in the Feature Access Code Assignment form.
If you intend to use a feature key in Operation, program a Paging key in the Multiline Set Key Assignment form or use Superkey (see Feature Keys for more information on Superkey programming).

 

[kwbMitel]

Let me guess, you're dialing the code with the handset in the cradle.

Must lift handset for loudspeaker page.

*******************************************************
Occam's Razor - All things being equal, the simplest solution is the right one.

 

[steveycarr]

Thanks for that guys, I've missed out the programming of the E&M Programming bits, I tried with h/set on and off but obviously neither would work without the programming done.

Once again many thanks I'll give it a whirl today.


Steve

!ExtraDunce