Custome paper size

[Aleathiel]

Hi all,

Been 6 hour I'm trying to find a way to make a code so that my report print on a 4"x24" label since I cannot change it to higher than 4"x13" byt the normal way and the user defined paper format is not bringing me a pop-up to enter my new size. If anybody could help me find a way to do it and tell me of a code that would work and where to put this code, any help would be greatly appreciated!!!

Thanks in advance.

Nathaniel Bell

 

[HandsOnAccess]

Please See thread703-1178510 last comment

 

[Aleathiel]

This one helped me a little but Im still stuck, since its only change the width and height of the section, not the width of the page itself, its like the printer doesn't recognize other format that is bigger than 4x13. I need to print all my detail section on a single 4x24 not 2 since the printer think there is only 13".

Thanks for any help!

 

[HandsOnAccess]

Just read and understand the code you will be able to implement Custom Paper Size to the same code.

You can set Height, Width, Right Margin, Left Margin, Top Margin, Bottom Margin, Size of Paper, Paper Orientation, just everything anything you want.

I want you to read, understand and customise it so that it will help you immensly in future. That is my intention.

The only limitation is the minimum margin and maximum paper size your printer supports. Apart from your printer limitation, you must be able to set all printer settings.

It will take some time until you get fully familarised with the said code.

All the best.

Regards,