CUCM Inbound calling

[danthephoneman]

Hi All,

I'm still a rookie at this call manager thing so I was wondering if you guru's can help me out. I am looking for some clear configuration steps on how to set up inbound calls to the CM. I am using 7.0 with a 2821 gateway set up with MGCP 1 FXO card and a T1/E1 card. what I am looking to clear up is how do I point the DNIS digits to the correct Extension? and how do I assign a FXO line to ring on the attendants phone?

 

[pndscm]

If you set up your Gateway as MGCP, CallManager will handle the delivery of the inbound calls. Assuming you will have a PRI on the T-21 card, you configure in CallManager, how many digits it will use to route the call. For the FXO, in CallManager you tell it what extension to send the call to.

 

[danthephoneman]

Thanks scm,

I see in cm where i configure the DNIS for the PRI, but under what heading will I need to look for the FXO?

 

[pndscm]

Attendant Dn or something similar. And BTW, CLID was not supported on the 2821 until IOS 12.4.24. I figured I'd say that be before someone said that CLID wasn't supported for FXO's running MGCP.

And I meant T-1 card above not T-21.

 

[danthephoneman]

Thanks again scm,

I read somewhere about the CLID thing.

so it is just a matter of changing it under Gateway>Endpoint
Port info under attendant DN.

Thanks for your help.