snootalope
IS-IT--Management
Ok...finally got CUCM 6 installed, both publisher and subcriber are rolling. Used DMA to pull all our data from 4.1.3 and it worked great. Got the new servers licensed and my test lab is now ready to test.
Well, I've already hit a brick wall. I plugged one 7940 phone up the CUCM and it registers just fine. I can see it in the admin page as registered. Great. However, I can't seem to change anything about the phone!
I change the extension, hit save, and then try to reset the phone. The phone just sits there and doesn't do anything. I yank the cable from the phone and manually reset it. It comes back up with it's old extension. ???
The CUCM and phones see each other, but their not listening... Am I missing something?
Also, I'm trying to upload new phone loads for the phones, but I can't seem to find the IPT Platform admin. How do I find that? That is what one uses for uploading new firmware right?
Well, I've already hit a brick wall. I plugged one 7940 phone up the CUCM and it registers just fine. I can see it in the admin page as registered. Great. However, I can't seem to change anything about the phone!
I change the extension, hit save, and then try to reset the phone. The phone just sits there and doesn't do anything. I yank the cable from the phone and manually reset it. It comes back up with it's old extension. ???
The CUCM and phones see each other, but their not listening... Am I missing something?
Also, I'm trying to upload new phone loads for the phones, but I can't seem to find the IPT Platform admin. How do I find that? That is what one uses for uploading new firmware right?