Cube Drill Through To Impromptu

[KJohn]

I am trying to create a drill through from a PPcube to an Impromptu report. I would like to use two of the dimensions (not measures) as filters in the report. I can activate the drill through on the cube build(Scope:Cube), but I can't seem to get the cube to send the selected dimensions to the report. I have used the same variable names. I am getting the "Warning - some of the filter information was dropped" Anyone have any ideas?
Thanks!
KJohn

 

[vijayleads]

I think you may not have defined all the dimensions in your drill through report correctly. The dimensions like you have in your cube should also be defined in the report and you can also define additional dimensions (which is why we use drill through in the first place). Check and see if you have done this. I am quite sure that you wont get the message about filter dropping once you fix the dimensions in the report.

let me know if it works for you.

thanks and good luck.