Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CTI 1

Status
Not open for further replies.

Alexaocr

Technical User
May 31, 2012
20
CR
I have a KX-TDE600 with 2 cabinets, 2 E1, NCV200, H323 and SIP telephony, 2 voice mails. In addition to this newly acquired License 3 party CTI kx-ncs3930.

The problem is that the NCV200 establishes the link with the central through port 33333, 3 party server also uses the same port.
So far there should be no problem, the matter is that the pbx is only allowing a simultaneous link which leaves out of NCV operate the server 200 or 3 party

NCV can say that the 200 works properly without a license and that if the NCV 200 is disconnected peer server works properly, the matter would be the number of links that can be set by the port 33333 to the center as currently it is a single bond that
would be illogical as it would leave one of the two devices out equally important in managing the customer call center.

Any ideas!!

Thank you
 
you Should use the panasonic csta mux to connect multi device & 3 party software to panasonic pbx
 
Do you mean KX-NCS2020XJ license? this not a Comunication Assitant license?

I already use rander aplication to see the activity from de pbx and third party licence ncs 3930
also need kx-ncs2020 license to connect both aplications?

Thank you for replay
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top