We are currently trying to set up an SRG 50 running off of a CSE 1000M and utilizing PRI on the SRG. We are having difficulties with the SRG recognizing and accepting the local PRI for inbound and outbound calling. Is anyone out there using this type of scenerio?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
CSE1000 and SRG 50
- Thread starter ttuckwell
- Start date
acewarlock
Technical User
Is the SRG a BCM 50? if so go to the BCM forum.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
This is a Signature and not part of the answer, it appears on every reply.
This is an Analogy so don't take it personally as some have.
Why change the engine if all you need is to change the spark plugs.
- Thread starter
- #4
the problems we're having are:
-can't get incoming call display
-SIP would not work, had to use H323
-when making outgoing calls there is a 6 second delay before any ring tone is returned.
-in SIP we could not get the DID on the local PRI to the SRG to be recognized.
-can't get incoming call display
-SIP would not work, had to use H323
-when making outgoing calls there is a 6 second delay before any ring tone is returned.
-in SIP we could not get the DID on the local PRI to the SRG to be recognized.
- Status
Similar threads
- Locked
- Question