CS1k E1 failing to work every morning

[reisve]

Hi
I have a CS1K,Rel 7.6, with a PRI/E1 NTBK50, that needs to be reseted every morning to work. The LEDs on the board face plate are all green, the LD 60 > Stat looks good, but the calls don't go trough until I reset the PRI. This has been since the software was re-installed.

Can any one help me please?

 

[bignose21]

Maybe take the link down and re download the PRI, also check the clocking is good once finished see if you are clocking up any errors on the PRI throughout the day

in LD 96
. dis msdl <l s c> all <-- disable the MSDL and associated DCH
. enl msdl <l s c> fdl <-- enl MSDL and force download the protocol software

LD 60
. disl l <-- disable PRI loop
. enll l <-- enable the loop

LD 96
. enl dch x <-- enable the DCH

LD 60
. stat loop <-- check the status of the loop all channels up no alarms
. rcnt loop <-- reset the counter for the loop
. ssck <l s> <-- Stat the clock for the MG make sure its locked to pri source
wait a bit
. lcnt loop <-- See if you are picking up any errors slip/frame/crc4 etc.