CS1000E not recognizing new TMDI card

[Cs1000noobnoob]

Hey everyone, pretty inexperienced with the CS1000E. We are looking to upgrade our E911 system, and its calling for a new TMDI card.
I have it installed, but for some reason cannot enable it from LD 96 or LD 48. I can see my original TMDI is installed and enabled, but it will not recognize the second one I just installed. There are no open slots in the switch, so I had to move lines from an analog card and remove it, and put the TMDI in its place. It is not in the same rack as the other TMDI, and it is installed above the MDG card. Currently the OOS is red, the ACT is green and the CC is red. Any tips or information is greatly appreciated.

 

[bhassell2000]

Did you make the slot a TMDI slot in CEQU?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[Cs1000noobnoob]

No I did not do that, how do you make it a TMDI slot?

 

[bhassell2000]

ld 17
chg
cequ
press enter until you get to DLOP
for mode pick if its a PRI
then at TMDI enter yes
press enter until you are back to req prompt


Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[Cs1000noobnoob]

Will this effect the currently installed TMDI card? Or is there some way to specify that card slot I want to enable as TMDI?

 

[Cs1000noobnoob]

Will this effect the currently installed TMDI card? Or is there some way to specify that card slot I want to enable as TMDI?

 

[KCFLHRC]

First of all what slot is it in? And no it will not affect the other one. And what is an MDG card?

 

[Cs1000noobnoob]

Ok the one I'm trying to add is in slot 20 0 1, and the first is in 0 1 2. I misspoke I meant to say MGC card.

 

[KCFLHRC]

So in the CEQU ath the DLOP prompt do this


>ld 17
CFN000
MEM AVAIL: (U/P): 98308990 USED U P: 5076882 266477 TOT: 103652349
DISK SPACE NEEDED: 309 KBYTES
DCH AVAIL: 251 USED: 4 TOT: 255
AML AVAIL: 15 USED: 1 TOT: 16
REQ chg
TYPE cequ
XCT
MGTDS
MGCONF
IPCONF
IPTONE
DLOP 22 24 esf This is loop,number of channels ,and extended super frame for a PRI. The 22 is an arbitrary number. Make it 1 higher than the existing loop
MG_CARD 20 0 1 This is your card slot
MODE pri
TMDI yes
LCMT b8s
YALM
T1TE
TRSH 0

 

[Cs1000noobnoob]

Figured it out, turns out the slot still had analog lines still attached, I removed them and was able to continue programming/adding the TMDI card. Thanks everyone!

 

[KCFLHRC]

You will also need to configure and have a clock controller on board for each media gateway that has a TMDI card