Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CS1000 UDP received / send lenght - newbie question 2

Status
Not open for further replies.

Aerodesliza

Programmer
Apr 10, 2008
282
DO
Where can I change the UDP received and send number lenght? I checked in LD 15 but I can only find the HLOC (Home location code)

Second question: How can I match the DNIS received with a station number? I use target line in the BCM but I don't how is work in CS1000.
 
I have no idea if this will effect the change you want, but there is a prompt "UDPL" under the VNR gateway in LD15

UDPL = Flexible length of Vacant Number Routing (VNR) Uniform Dialing Plan digits (UDP). Enter the maximum number of UDP digits expected by VNR.

[©] GHTROUT.com [⇔] A Variety of Free Resources for Nortel Meridian/CS1000 System Administrators
 
The second question about assigning DDI's, you use LD 49 and program an IDC (Incomming digit conversion) table where you assign received digits to sets. you can do ranges say you receive 6 digits but extensions match the last 4.

e.g.
receive 565xxx and extenions are 5xxx you could put in a single entry of:

565 5

IDC tables are assigned to the RDB (Route data block) in LD 16.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top