Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CS1000 to Unity analog trunk DTMF issue

Status
Not open for further replies.

motox2

Programmer
Jun 21, 2007
426
GY
So i have a CS1000 (7.6) connected to a Unity through a dialogic DMG2000. PRI trunks to Unity AA work and can pass digits normal. However Incoming analog trunk calls from the CS1000 can reach the unity AA, but cannot pass any digits after connecting to the AA. My guess is that's its not the Unity or the Dialogic, but something in the CS1000 analog trunk setup or RDB for the trunks. For the life of me cannot figure this out and any help would be appreciated. Thank you kindly!!
 
**UPDATE** I have not been able to resolve this yet, but i did discover if press 0 twice, the system recognizes that and passes the call, otherwise if not, the AA will just play the recording 3 times then hang up. Maybe this will help. Fingers crossed!!
 
Sounds like the EOD Timer. In the RDB make SPCT IMM. Also post the route and trunk here
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top