We had some queries setup on a particular directory that have mysteriously disappeared. When we 'proceed without dictionary', it appears that the report completes. Is this possible or do we have to create new queries (sub reports) and replace/link them to the existing reports?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Crystal 8.5 - cannot find dictionary
- Thread starter deborahyr
- Start date
synapsevampire
Programmer
I'm not sure, but I'd think that you're going to have problems.
AT any rate, dictionaries were never a good idea because of their proprietary nature, and Crystal no longer supports them in CR XI, so you might just consider rewriting the reports now using database Views or Stored Procedures.
-k
AT any rate, dictionaries were never a good idea because of their proprietary nature, and Crystal no longer supports them in CR XI, so you might just consider rewriting the reports now using database Views or Stored Procedures.
-k
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question