Crystal 10 Stored Procedures Refresh

[sbcute]

Has anyone else encountered problems refreshing their data source IE when using a stored procedure as the data source?

If you make a change in your stored procedure and try to refresh the data source in Crystal, it doesn't always refresh. Short of recreating the report with the revised stored procedure, what is the best way refresh your data source?

Help would be much appreciated.

 

[synapsevampire]

Please remember to post technical information, such as the database type and connectivity.

Using Database->Verify Database tells Crystal to check the data source for changes. Once you've done that, save the report and it should be fine.

However there are some other concerns when using improper connectivity, such as the Oracle supplied ODBC driver as opposed to Crystal's own.

-k