Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CRON _OS4K V10

Status
Not open for further replies.

LAAZ

Systems Engineer
Aug 4, 2021
111
IN
Hi Friends

is it possible to increase the number of position table in CRON command from 256 to more than 25000

As the more than 300+ guest rooms extension has to forward all calls to operator during NIGHT and deactivating the same in DAY .

Is there any other way to configure it.

In the command the POS is showing maximum 256.

Please help me in this issue.
 
You can't change the maximum number of commands in CRON, it's set in the AMO.

You could try things with ITR groups or BERUM/BERUZ and try and force an intercept to attendant.

But the easiest way is to store a macro on the HD, and point CRON to it. CRON will run the macro.

Example.

ADD-CRON:1,P,0,22,*,*,*,":pAS:DIVERTON";
ADD-CRON:2,P,0,7,*,*,*,":pAS:DIVERTOFF";

 
i am not sure,maybe u can try the GROUP DND feature.
1 set the room station cfdnd to operator
ADD-ZIEL:TYPE=FWD,SRCNO=1000&&1300,SI=VCE,DESTNOF=0,DTYPE=CFDND,ITYPE=GEN,CFVAR=SYSTEM;
2 set these room station in a group
scsu/sbcsu itr=xx
3 active and deactive the group dnd in acwinip operator
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top