I have a document that begins as a 8.5h x 7w (half legal)doublesided pages. I then build a booklet (2 up saddle stitch). I entered the amount of creep I have estimated for the paper I am using (about 3/16"
. As near as I can tell, the creep IS there, BUT it seems to be pushing everthing on my spread towards the right instead of towards the middle.
This of course results in everything be off in alignment and some pages being cropped too closely when the booklet is face trimmed. I currently have margins of .25" on outside, top and bootm and .5 on the inside.
I have searched my books, the Adobe site and one other help forum, as well as joining a group at Yahoo, to no avail. If any one has ANY idea about what might be going on here, please let me know.
-Amy
. As near as I can tell, the creep IS there, BUT it seems to be pushing everthing on my spread towards the right instead of towards the middle.This of course results in everything be off in alignment and some pages being cropped too closely when the booklet is face trimmed. I currently have margins of .25" on outside, top and bootm and .5 on the inside.
I have searched my books, the Adobe site and one other help forum, as well as joining a group at Yahoo, to no avail. If any one has ANY idea about what might be going on here, please let me know.
-Amy