When you first set up the BCM 400 and create a rnage of extention numbers ( I think it automatically creates about 200) can I go back in and create more in ranges that I specify? Right now I hvae 8001 to 8299, can I now make another range from like 2100 - 2199 if I wanted?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Creating new extention ranges
- Thread starter plshlp123
- Start date
- Thread starter
- #3
- Thread starter
- #5
I finally am getting around to doing this but just wanted to make sure I can enter the range that I want in as the new scheme. I am removing a clock of 20 numbers from the scheme but entering a different number range.
ex. 8414-8454 and would like to add 6230-6249
I want to keep all the 8,00 series numbers in tact but just want to add these specific number to that list. When I'm in the DN Renumbering page it asked me to give the range I want to renumber than at the end it asked my to Apply? Where does it ask me to put in the range I want?
ex. 8414-8454 and would like to add 6230-6249
I want to keep all the 8,00 series numbers in tact but just want to add these specific number to that list. When I'm in the DN Renumbering page it asked me to give the range I want to renumber than at the end it asked my to Apply? Where does it ask me to put in the range I want?
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question