Creating groups within callmanager 4.1.3

[Quanza]

I'm trying to create phone groups within the callmanager.

What i want is that if a certain number is dailed, only the phones that are attached to that number will ring and not all the phones.

I have Cisco 7941-G IP phones here, with 2 lines setup (one 00 (shared line) and the other with the number of the person that owns the phone).

If i dial the 00 number, all the phones ring, that is good. Now i want to take the 60 number and let only 2 of the phones ring instead of all the phones.

How can i do this?

 

[pndscm]

I'm not sure I understand fully what you're doing but I'll take a shot at it. It sounds to me like you want X number of phones to have a shared line but only 2 will ring on an incoming call.
If you only want 2 of the phones to ring, change the settings on the Directory Number page that pertain to ringing from System Default to what ever you want, Flash Only, Ring Once, etc. for the phones you DON'T want to ring.
If I missed your point, please clarify.

 

[Quanza]

Maybe this helps:

I've got 2 numbers, 00 and 60. I've got 6 phones.

If the number 00 is dialed from outside, all the six phones ring.

If the number 60 is dialed from the outside, only two of the six phones have to ring instead of all the phones.

I can't add more directory numbers to the phones, it only allowes me to add 2 directory numbers.

 

[pndscm]

Have you tried setting up Hunt Lists and Line Groups?? You could then Broadcast the '00' call to all the phones ringing for 00 and on a second group Broadcast to only the 2 phones you want to ring for '60'. '00' and '60' become the Hunt Pilots for each respective Hunt Group. In this way each person can still have their personal DN on either button. If some calls '00' all the personal DN's ring but if someone dials the personal DN, only the single phone would ring.

 

[Quanza]

I have just created the hunt lists and line groups. But whenever i try to dial de 60 number, all i get is a busy tone...