Creating a full spread inside an A5 document.

[AminoCreations]

Hi and thanks for reading. I am creating a bit of a brochure, A5 format, but I want to create a center spread in the middle of the brochure, so it will pretty much be like an A4 sheet. How do I set up Coral Draw so that I can do this?

 

[javabearSTL]

Is this a "booklet?" If so, you can use the booklet layout and choose to show "facing pages", which would show you a particular spread... the question is also is this for the "center page"?

 

[AminoCreations]

thank you very much for that it worked a treat.

My book is an A5 document so I had to change the page to an A4 sheet from A5.

However, I must explain how I did this since it took me a while to figure out where the options were.

View>Grid And Ruler Setup> then on the popup screen Document>Page>Layout

Layout = Book and
Check the box option for Facing Pages. After that, you should be fine. apart from having to move guidelines about like I had to...

Other than that, thanks bud, very helpful.