Creating a 2-up or 3-up report 1

[RenaG]

I am using Crystal 10.

I have a report that has just two columns:
ID | Location
2 | Simulator
3 | Reception
180 | Lab
etc.

I would like to show these 2 columns across the page 2 or 3 times:
ID | Location ID | Location ID | Location
2 | Simulator 3 | Reception 180 | Lab
207 | PICU 292 | Clinic 311 | Consult Rm
etc.

I hope that comes across when I post this.

Is there a way to do this? Thanks!

 

[lbass]

Go into the section expert->details->format with multiple columns->layout tab->enter a width and gap (probably about 2 in and .5 in) that will force the three columns->across then down. Play with the dimensions until you get the desired result.

-LB

 

[RenaG]

How many times have I looked at that window and I couldn't remember that ;-}.

Thank you lbass. You have come through again with flying colors.