I have just installed HP toptools 5.52 on our network to snif for problems, the only thing it comes back with is CRC alignment errors.
Assuming the cables are all OK CAT5 etc. I think it my be to do with Full and Half Duplex settings on the end nodes.
I don't really understand this part but assume that both the switch and the end nodes have to be set up the same.
we use 3com cards that are auto confirgured so I thought this would sort its self out.
Can anyone shed any light on this please..
Assuming the cables are all OK CAT5 etc. I think it my be to do with Full and Half Duplex settings on the end nodes.
I don't really understand this part but assume that both the switch and the end nodes have to be set up the same.
we use 3com cards that are auto confirgured so I thought this would sort its self out.
Can anyone shed any light on this please..
