CR 10 OLAP error

[scooterny]

Folks,

I am running CR10, which I just recently reloaded onto a new PC. I was trying to create an OLAP report, but when I opened the Crystal Reports gallery ( in File - New ), the OLAP report creation wizard wasn't there. Further, when I tried to open a copy of another OLAP report I had on my hard drive, I got an error that said "Failed to open document" and then "OLAP Cube connection failed". Not sure why I am getting this error. Everything else seems okay, but maybe my install didn't go so well, or I didn't load something I should have. Any advice? Thanks so much.

Scott

 

[MJRBIM]

It's been a while since I used CR-10 for OLAP, but I think that you need to deploy an OLAP client-driver on the PC before you install CR-10.

If you still have the Old PC - I would check for an OLAP client-driver.