Cortelco Millennium Lab System Help

[buttercool]

Hello folks,

I’ve come into the position where I can pick up a DBCS8 for a reasonable price for my home lab (it’ll join an AVAYA g3CSI
, Nortel 11c and Cisco CUCM 12 tied together with QSIG PRIs on a c2811) and wanted to see if anyone here would be willing to help guide me on a few things:

- Does anyone happen to know where I could obtain a Cortelco Millennium programming manual? Exhaustive online search has only yielded phone user guides. Even some basic guidance around printing the existing config would be immensely helpful (have already found the save config command so that’s covered)
- Is there a known password reset process? I’ll likely need to perform this as this is a used Millennium previously from a school and the password is unknown.
- I found the serial pin out on another forum so I’m probably good there but hopefully the manual can confirm this as well.
- I’ve seen other folks use teraterm to manage the system so I think I’m good there too.

I have many fond memories seeing these in Circuit City stores as a kid. My end goal is to get a few of the 4 or 2 wire digital Cortelco phones working along with a PRI to tie it back to my other lab systems (I’m hoping the Millennium can also do QSIG PRI like the g3 and 11c)

Any help would be much appreciated.

Thank you
bc

 

[LoPath]

Not sure if you tried, but it may be worth chatting up their tech support.

https://www.cortelco.com/support.php

Their site says "Our Technical Service Department is staffed with knowledgeable and dedicated employees who have been with Cortelco for many years." so maybe one of the old salts would be helpful?

LoPath
Maintain HiPath 4000 V5 & V6, OpenScape Xpert V4 & V6, OpenScape Xpressions V7, OpenScape Contact Center V8, OpenScape Voice V9