Hello,
We have a pc with Corel12 and Ioline 301 which is hooked up to the ioline cutter. We would like to start using it to cut film for team #'s/names, etc. Ioline says it will import .plt and .dxf files, but when I set something up in Corel (simple test text; converted to curves) and output it as a .plt, it shows in Ioline as angular; all the nodes have been converted to corner points! SO...
-is .plt or .dxf preferable?
-how do we avoid this angular rendering?
-any other settings/adjustments we are going to need to watch out for?
Any information/links will be greatly appreciated! Thank you very much for your time & I hope it's warmer there than here...
-E
'There is no LEASH LAW for the IMAGINATION!'
myspace.com/erixworx
We have a pc with Corel12 and Ioline 301 which is hooked up to the ioline cutter. We would like to start using it to cut film for team #'s/names, etc. Ioline says it will import .plt and .dxf files, but when I set something up in Corel (simple test text; converted to curves) and output it as a .plt, it shows in Ioline as angular; all the nodes have been converted to corner points! SO...
-is .plt or .dxf preferable?
-how do we avoid this angular rendering?
-any other settings/adjustments we are going to need to watch out for?
Any information/links will be greatly appreciated! Thank you very much for your time & I hope it's warmer there than here...
-E
'There is no LEASH LAW for the IMAGINATION!'
myspace.com/erixworx