My Corebuilder 3500 fails several
diagnostic tests during startup and does not
complete the boot sequence.
one of the errors is that the interface card ID
is not the same as in the firmware.
also I think i need to restore the software via
the ethernet management port
-- there are three internal pushButtons
labled RST, NMI, SRU
What do these buttons do ?
I do have a 16MByte Flash Memory card but
i dont think that is required to restore system
however it would be good if system software on it
diagnostic tests during startup and does not
complete the boot sequence.
one of the errors is that the interface card ID
is not the same as in the firmware.
also I think i need to restore the software via
the ethernet management port
-- there are three internal pushButtons
labled RST, NMI, SRU
What do these buttons do ?
I do have a 16MByte Flash Memory card but
i dont think that is required to restore system
however it would be good if system software on it
