Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Copying an existing extenstion to a unused DN to and unused TN???

Status
Not open for further replies.

Page7

IS-IT--Management
Apr 13, 2010
14
IE
I'm following directions that I got off of ghtrout.com. I'm trying to copy the data from an existing extension to a new one but I don't come to the point where it allows me to enter in the new TN and DN I want it to copy to it only prints out "SCH0130". Any help would be greatly appreciated! Here's how I'm going about it and the outcome:

>LD 10

PBX000
MARP NOT ACTIVATED

MEM AVAIL: (U/P): 2807987 USED U P: 133674 89378 TOT: 3031039
DISK RECS AVAIL: 1024
ANALOGUE TELEPHONES AVAIL: 1 USED: 7 TOT: 8
CLASS TELEPHONES AVAIL: 0 USED: 0 TOT: 0
WIRELESS TELEPHONES AVAIL: 0 USED: 0 TOT: 0
WIRELESS VISITORS AVAIL: 0 USED: 0 TOT: 0
ACD AGENTS AVAIL: 9 USED: 1 TOT: 10
AST AVAIL: 200 USED: 0 TOT: 200
TNS AVAIL: 2356 USED: 144 TOT: 2500
DATA PORTS AVAIL: 2500 USED: 0 TOT: 2500
PHANTOM PORTS AVAIL: 2500 USED: 0 TOT: 2500

REQ: CPY 1

TYPE: 500

CFTN 004 0 00 13

SCH0130
CFTN
 
it looks like 4 0 0 13 is not an aanloge extension (500)
 
How do I find out what kind of extension it is?
 
do this:

REQ: prt
TYPE: tnb
TN 4 0 0 13

If at type = 500 you it is an analoge extension
 
if 4 0 0 13 is uneq, it will not prt. stat 4 0 0 and you will see if it is dig or analog

Mato' Was'aka
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top