convert A-Number in transit 1

[rfpup]

Hi to all,

I have a scenario a little different from this one below

http://www.tek-tips.com/viewthread.cfm?qid=736951#post

I want to thank Whosrdaddy for his post here.

I have two public connection A1 and A2 instead of 1 in the case above.
PBX C is calling to A1 and A2 through TSE 4.1 sp2 using the same only route between TSE and PBX C
Extension 3400 part of PBX C is calling to the PSTN and its A-number have to be displayed as following:
When call is going to A1 A-number has to be displayed like 123400
When call is going to A2 A-number has to be displayed like 453400

Can someone suggest how to deal with this case?
Thank You in advance

 

[rfpup]

I could found the solution via activating Enhanced sent A-number in D24 of ADC for each of the routes connected in PSTN1 and PSTN2