americancurly
MIS
I have upgraded my three servers from Solaris 6 to 7. When I do the upgrade, I run into problems where the controllers renumber. Why does this occur? Any solutions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
controllers renumbered
- Thread starter americancurly
- Start date
- Status
Probably with the origonal install, the controllers were added over a period of time so they were numbered in the order they were added. The upgrade would have probed for the hardware setup and then numbered the controllers in the order it found them. I don't know of any way to keep the numbering of the controllers.
- Status