Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
control unit with IPO SE license issue
- Thread starter mosalah73
- Start date
- Thread starter
- #4
SCN line out of service
- Thread starter
- #5
the configuration and network are good, but there is another problem when I try to log in to the server edition from port 7071 gives me the password is wrong, although I log into the system from port 7070 with the same password
The past few times I've added an expansion system to an existing SE network, I had to restart the IPO service on the primary/secondary servers in order for the SCN line to the new expansion to go in service. Once that was done, the line was in service and the expansion checked out a license.
Ekster
Systems Engineer
- Sep 30, 2005
- 293
What Version Of IPO? There were some 11.1 versions that didn't like strange symbols in the password.
Are you using any of these symbols in the password:
$ & ( )
If so, try setting a basic alphanumeric password without special characters and see if that works.
put the line in proprietary mode on both side instead of websocket, if the line is out of service it will never work, licenses are echange with this link
Similar threads
