BCM 450 rls6, I have 100 target lines set with the default control set. I am going to be putting them into a different service with a different control set. Does anyone know of a way to change them to another control set without having to do them 1 at a time?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Control Set? 1
- Thread starter hawks
- Start date
As far as I know you have to do them one at a time...if the 450 is the same as the 400.
I usually preferred to do them through the telset because the GUI response time was so danged slow...
"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein
NCSS NCTS NCTE CS1000E
Mitel 3300 4.2 basic & advanced, 5000 4.0, NuPoint I&M 4.2
I usually preferred to do them through the telset because the GUI response time was so danged slow...
"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein
NCSS NCTS NCTE CS1000E
Mitel 3300 4.2 basic & advanced, 5000 4.0, NuPoint I&M 4.2
-
1
- #3
Not 100% on this and can't test/confirm at the minute. But I think you could program the new control set dn on 1 line, hit copy and then select the other lines, hit paste. It will then give you a dialogue box asking which data you want to paste. Pretty sure control set is one of them. Select that and you should be sorted.
- Thread starter
- #4
- Status
Similar threads
- Locked
- Question
- Locked
- Question