control codes for SCD-400 micronics pole display

[LordGarfield]

Hi,

I have attached a pole display on the com2 port of a pc.
on com1 there is a thermal line printer.

the pole diplay is a SCD-400 of micronics.

Both devices are controlable by control codes.
I have the control codes for the printer and this one works fine.
But I do not have them for the pole display.

I need the control codes that do this stuff:

a initialization code
a clearing code (normaly it should be char(12) but that does not do the trick)
a code to print on the first line
a code to print on the second line.

I search everywhere on the internet but can't find the good codes. can anyone help me?

best regards
Roel.

 

[LordGarfield]

Hmmm

Nobody has codes for this display?

 

[DTSMAN]

I think you will find that most of the members that monitor this forum don't write POS software. We all use POS softwares that are already coded to work with specific hardware and if we need to work around that we use OPOS drivers that the manufacturer provides. May try one of the forums on writing code and I am sure someone will point you in the right direction.