Console 1

[Arugg]

I am having an issue. I can dial into the PBX (Option 61C), but I never get the > prompt. Here's where it hangs:

Procomm Plus Ready!
Procomm Plus Ready!



1 Read Mass Memory
2 Search Mass Memory
3 Count Matching Strings in Mass Memory
4 Status Report
5 Display I/O Port Status
6 Clear Mass Memory
7 Go Transparent to Host Port
X Logout


Command: 7
Which host port? (1,2) 1
OK - use <control>] A to terminate


-----

Is there something wrong?

 

[Telco01]

enter 7 key followed by the enter key.
enter 1 key followed by the enter key.
hit the enter key again, that should be your PBX.

 

[johnpoole]

that's an seb(site event buffer), they can be programed to monitor for alarms and do a remote notification.. you can have two serial ports connected to that device, as posted 7, 1 will take you to port 1..

john poole
bellsouth business
columbia,sc

 

[Arugg]

I do 7, 1 but it does not let me in. I have been able to do this in the past. On Wed I had to reboot the switch because of a lock up. Since I have not been able to get into the console. I can do so thru OTM Terminal but I need to be able to do it remotely too.

 

[jbrown1217]

Go to LD 37 and enter "stat tty" the tty that is connected to your SEB is most likely disabled. Re-enable tty's that are disabled.

 

[Arugg]

Awesome!!!!! Thank you!!! That was it.