connetion between Cisco CUCM and Ericsonn BP250

[baccar]

hi!
we need to connect our new CISCO CUCM version 10.5.2 to our existing ERICSSON BP250.
We only have IP interface on the CISCO CUCM.
Please help me to know the reference of the ERICSON BP250 card (s) and licence (s) I have to buy in order to make connection between the both PABX.
Thanks!

 

[xs650]

BP is phased out and new sales is stopped, so normally you get no new boards for this pbx.

If you find some boards you need for a H323 trunk connection:
IPU+DSM+IPU cable+VOIP Green pack(4 channels)+ Networking license

 

[baccar]

HI xs650!
yes BP is phased, but I find some suppliers that can sell some boards.

These are the references that I found " BTU-D (30), ISDN30 Trunk Card Board for ISDN Multi (30 channels) including registers for MFC (R2), MFE signaling and DTMF. Part Number: ROF 1575112/1".

Does that Item include the parts and the license you have mentionned (IPU+DSM+IPU cable+VOIP Green pack(4 channels)+ Networking license ).

 

[xs650]

You wrote about IP interface that you want to use but the BTU-D uses ISDN primary rate?

When you want to use an ISDN primary interface for the networking you can use the BTU-D.
When you want to use IP you need the IPU board.

 

[baccar]

HI xs650!
you are right,
The both interfaces (ISDN and IP) can be used with our CISCO CUCM.
since we did not find till now a supplier four IP Board, I have suggested the ISDN interface. Do you think that the reference of BTU_D item I wrote is complet and suffisant (including licenses)?

 

[xs650]

Yes, you can use the BTU-D with ROF 157 5112/1, just take care that the board is equipped
with ISDN firmware (RYS 102 524) and not CAS (RYS 102 512).

 

[baccar]

thank you!