connection through other firewall(very urgent)

[Guest_imported]

Hello!

I have Raprot Firewall 6.5, there are 4 interfaces on firewall(local subnet, DMZ, Internet, other enterprise)
Ip address on the interface which is connected to other enterprise is 10.200.2.1, other firewall ip is 10.200.2.2,
they have local network 10.200.4.0/24, what should i do in Firewall to make connections from our local subnet to this enterprise subnet.

Regards,
bumbuls

 

[lanceja]

I am not sure if you have done the following but I would:
1. I would check the route table (route print) on both firewalls and make sure that you have a route going between the firewalls.

2. Setup rules on both firewalls to let connectivity occur.

3. Try to ping/tracert between the sites to see what happens.

Hopefully this will help you out.

 

[rene1000]

In your LAN's Default gateway, make sure there is a route to the enterprise network with a gateway set to the local interface of your firewall (10.200.4.?)

in the enterprise network, make sure there is a route to the local LAN with a gateway set to the local interface of the firewall on the enterprise site (10.200.2.1).

next, create an entity for your local lan (10.200.4.0) and an entity for the enterprise network (10.200.2.0).

then create a rule which allows "all protocols you want" from entity "your_lan" to entity "enterprise_network". (when you are testing you can use the protocol "*all", this makes testing a lot easier !)