Connecting two definities using E1

[shalamar]

Hi, I'm trying to connect two Definities in two remote locations using E1. My 1st challenge is that I'm not exactly sure which circuit packs I need (Tie trunk or DS1).
Can somebody please help.

 

[definityandcmuk]

Shalamar

DS1 for E1 do you need help with the configuration

 

[shalamar]

Thanks. It would be real nice if you can help me with the configuration now, since that will be the next stage.

 

[definityandcmuk]

DS1 CIRCUIT PACK

Location: 01A09 Name: MXGB282510
Bit Rate: 2.048 Line Coding: hdb3

Signaling Mode: isdn-pri
Connect: pbx Interface: peer-master
CentreVu Long Timers? n Peer Protocol: Q-SIG
Interworking Message: PROGress Side: a
Interface Companding: alaw CRC? y
Idle Code: 01010100 Channel Numbering: timeslot
DCP/Analog Bearer Capability: 3.1kHz

One side will be a & peer-master, one side will be b & peer-slave


Slip Detection? y Near-end CSU Type: other

 

[definityandcmuk]

SIGNALING GROUP

Group Number: 5
Group Type: isdn-pri
Associated Signaling? y Max number of NCA TSC: 15
Primary D-Channel: Max number of CA TSC: 15
Trunk Group for NCA TSC: 5

Trunk Group for Channel Selection: 5
Supplementary Service Protocol: b

 

[definityandcmuk]

In the trunk group make sure you have the following parameters set (will be too complicated to paste the screen)

page 1
group type: isdn
direction : two-way
carrier medium: pri/bri
service type: tie
Supplementary Service Protocol: b
Digit Handling (in/out): overlap/overlap

page 2
send name: y
send calling number: y
numbering format: private
send connected number: y


this setup is for an E1 2MB circuit in England

 

[shalamar]

Thanks so much.