Connecting KX-TDE100 to NS1000 over QSIG/voip (IPGW)

[Waheed Nazir]

Hi,
I am trying to connect TDE100 with NS1000 over IP NETWORK. i have below extension plan,

TDE100, 28XX
NS1000, 29XX

Could anyone help me how to connect both pabx and able to dial each other extensions?

 

[inlsp05]

Hi you can use sip trunk or pri or qsig
In tie table you can provide other pbx code for direct dialibg.

http://telfonika.blogfa.com

 

[obtsystems]

I would use IPGW card as it is designed for this job, QSIG is old out dated method
you have to setup a vpn between both systems

you will have to clear 29 on the tde and 28 in the ns1000 in flexible number plan so you can put them in other pbx on opposite systems

in the gateway card you gave to setup ips of the systems in GW settings and tell the system in DN2IP what numbers go out that gateway

you also have to setup private network digits to trunk the ip gateway lines are on, Default is 7

check in hunting pattern that the other system lead numbers are here or the calls wont come in.

that's is a brief outline of what you have to do. see how far you get with that

one thing is you have to tell the system in licencing what the sip trunk licence is being used for, trunk or gateway. that is on the top of the page

 

[Waheed Nazir]

Hi OBTSYSTEMS,
Thanks for your detailed reply. Could you provide me any document which have sample configurations steps? I will be grateful to you.

 

[Waheed Nazir]

Hi obtsystems,
Thanks for your support. I have configured successfully and now able to call other PABX extension over IP network through VOIP CARD.

Waheed
Net Link Technology Solutions Pvt. Ltd.

http://www.netlink.com.pk