Connecting BC8 and MX-ONE

[lpb612]

Hi everyone!
I need to connect one BC8 with a MX-ONE. I have a
TLU76/1 board in BC8 and a TLU76/11 in a MX-ONE.
Are there basic configurations to the ROCAI, RODAI in both sides?
Why I need to know?

Thanks!

 

[lpb612]

I think that I have to try alone

 

[slash50]

You will need to configure the systems to use Q-sig. This is fairly simple, but I don't have some examples to hand.

 

[Monrovia]

Sample

Qsig between bc12&bc12

MASTER SIDE:

ROCAI:ROU=XX,SEL=713000000000012,TRM=4,SERV=3110000010,TRAF=00151515,SIG=311110000031;

RODAI:ROU=XX,TYPE=SL60,VARC=00000350,VARO=00300000,VARI=05520000;

RODDI:DEST=YY,ROU=XX,SRT=1;

ROEQI:ROU=XX,TRU=1-1&&1-15,EQU=XX-XX-XX-1;
ROEQI:ROU=XX,TRU=1-16&&1-30,EQU=XX-XX-XX-17;

KSCAC:DIR=XXXX,ADC=0010000001000;

SLAVE SIDE:

ROCAI:ROU=XX,SEL=7130000000000010,TRM=4,SERV=31100000010,TRAF=00151515,SIG=311110000031;
RODAI:ROU=XX,TYPE=SL60,VARC=00000350,VARI=05520000,VARO=00400000;
RODDI:DEST=YY,ROU=XX,SRT=1;
ROEQI:ROU=XX,TRU=1-1&&1-15,EQU=XX-XX-XX-1;
ROEQI:ROU=XX,TRU=1-16&&1-30,EQU=XX-XX-XX-17;
KSCAC:DIR=XXXX,ADC=001000000100;

This is found in one of the thread here some time before, To confirm the values you can go for a search

 

[lpb612]

Thanks guys for help. I looked the previous thread. I will try the parameters. Afterwards, I will post the result.

 

[slash50]

Make sure you have program unit SLP60 in BC8 lim

 

[lpb612]

Hi Friends!
Thank you so much!!! You're the best!
Sorry for the long time. I tryed the values and it worked. Just one note, the parameter SERV has 10 digits. I used SERV=3110000010.
Thanks again for slash50 and Morovia!!!