Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Connecting Aspect DCP

Status
Not open for further replies.

vinayvnair

Technical User
Jun 13, 2010
10
I am getting a message "HTTPSRV connect" in DCP display.All the services are started.Please help me over this issue
 
We actually had this happen before several times while installing DCPs, it is very common. It is a Ethernet connectivity issue of some kind imho. Please confirm the Ethernet connection between your DCP and the TA server is using the ENET port. Check speed and duplex settings match or use auto/auto. You should be able to login to the associated Linux TA server using putty and ping the DCP over this link. (Assuming your TA server is running, which may be a problem..) Use a traceroute to confirm you are pinging the DCP over the right TA server interface. Make sure the TA server's firewall or SE Linux isn't blocking the connection. Confirm the ATNET interface is also connected to an Ethernet switch. ATNET is like the voice vlan. ENET is a private network with two hosts, the TA and the DCP. The DCP obtains its ENET IP address from the TA via a DHCP discover message. Depending on your system version, the TA handles its DHCP server a little differently. Once the DCP gets it's ENET IP, it downloads its config from the TA. Much of the DCP config info exists in the TA's HOSTS file. If layer 2 connectivity looks OK, check the layer 3 addresses assigned in the HOSTS file of the TA. Be very careful making changes if you aren't comfortable hacking Linux. You can really cause a disaster here if you make a mistake. Sound like your DCP is down anyway, so I hope this helps somewhat.
 
Ichanged the default gateway in hosts.I also gave a restart to the network.Now the DCP is displaying "0".Thankyou very much for your reply
 
Hello,

About DCP connection, have someone ISDN's connections from EMEA carriers connected? Please tell me what configuration have on the DCP, because i have a lot of errors on the interfaces.
Thank you.
 
Can you please specify the errors you are getting on the interfaces
 
Hello,

I have RAI_CRC, Yellow alarm. Maybe DCP not supported in my country. If you have one connection configured please send me the configuration of circuit.
Thanks in advantage.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top