Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Connecting ANH to Cisco using frame relay
- Thread starter Katob
- Start date
Do you have your own Frame Relay switch in your lab? Probably need to make sure to LMI is set to Rev 1 LMI on the ANH. That's what Nortel calls Cisco's LMI.
Nortel does something called Service Records when setting up Frame Relay. Are you going to have more than one IP interface on the Sync connector of your Nortel box??
Should be fairly simple...ask a few questions and I'll see if I can answer them. You probably need something called Site Manager to configure your router...(SNMP GUI)...it can be configured via the CLI, but is easier to do most things via the GUI.
- Status
Similar threads
- Locked
- Question