Can anyone help with connecting a terminal sever(MRV) to a netpath seb modem. I need to know the pin outs on the two ends of the RJ45 connections. I seem to have the port on the mrv and the pty configued correctly. The pty is enabled so it's talking to the mrv, but the two units are not talking. Any help would be appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Connecting an MRV terminal server to Netpath Seb
- Thread starter gteabc
- Start date
thattekguy
Vendor
Your Netpath goes into your elan hub, also the MRV terminal server goes into your elan hub, make sure you set up the correct IP range on both and you should be good.Should be a straight thru patch cable.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
