connecting a VT to a Sun Ultra1

[Guest_imported]

Hello!
I have a Sun Ultra1 connected to a VT that recently has broken. I connected another VT (that I'm sure works well), but it doesn't work. I suppose the problem are the configuration parameters of the VT (parity, stop bits, etc), but I don't know how to see these parameters in a Sun Solaris 2.6 OE and change them if necessary. ¿Someone can help me? Thanks a lot!

 

[cfsalmeida]

Probably you will not need to change nothing on Solaris check you VT configuration, if you are using comm1 put comm1=RS-232(usually on Global parameters), then check Communications Setup:
8 bits no parity
1 Stop bit
Transmit = 9600 or speed or Transmit speed (depends of VT model).

Hope this helps,

Regards,

Carlos Almeida,

 

[Guest_imported]

Yes it works!

Thanks!