connecting a Merlin to a Definity PBX

[alarmcallpending]

Can you connect a Merlin to a definity switch via a T1 and use the definity trunks for inbound and outbound access?

thanks

 

[alarmcallpending]

OK fiured out inbound, single LDN goes to station call forwarded to dummy number, ars routs dummy number to trunk going to the Merlin.

Outbound, (access, tie?) trunk from Merling goes active with an outbound call, want to to connect to ANY available member of the definity outbound trunk. Looked at access endpoints, but it is tied direct to a single DS0 (which might be active with a Definity outbound call).

ideas?

 

[alarmcallpending]

OK figured out inbound, single LDN goes to station call forwarded to dummy number, ars routs dummy number to trunk going to the Merlin.

Outbound, (access, tie?) trunk from Merling goes active with an outbound call, want to to connect to ANY available member of the definity outbound trunk. Looked at access endpoints, but it is tied direct to a single DS0 (which might be active with a Definity outbound call).

ideas?