Hello,
I'm trying to connect 2 mmcs together. One is in Belgium the other is in France.
I create everything same as the other side but as I enabled the loop I receive DTA300-slip repetition-errors.
To fix the problem I've already try to:
- change settings of Clock Controller => all connections go down and create chaos ('t was extremely funny)
- change to internal clock check => It may not be.
- change errors threshold to avoid losing connection => unsuccessfull.
I despair!
Somebody would have an idea? or better, a solution?
I'm trying to connect 2 mmcs together. One is in Belgium the other is in France.
I create everything same as the other side but as I enabled the loop I receive DTA300-slip repetition-errors.
To fix the problem I've already try to:
- change settings of Clock Controller => all connections go down and create chaos ('t was extremely funny)
- change to internal clock check => It may not be.
- change errors threshold to avoid losing connection => unsuccessfull.
I despair!
Somebody would have an idea? or better, a solution?