Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Connect Mitel/InterTel 5000 to Cisco Call Manager

Status
Not open for further replies.
mloraditch

mloraditch

IS-IT--Management
Jun 3, 2005
2
US
I am trying to setup a T1 trunk between an InterTel 5000 and a Cisco 2651XM Router that is MGCP controlled by CCM. I have both sides setup as CAS T1s with E+M Wink. From the Cisco side everything appears to be ok, I see the T-1 Up, i see it dialing across the T-1 and passing digits but on the intertel side I don't see much of anything, but then again i'm not really sure what i am looking for I don't see much of anything useful in the logs or the diagnostic monitor so I'm not sure if what's going on on the intertel side. Does anyone have any experience with this or any insight?
Thanks in advance!!!
 
Status
Not open for further replies.

Similar threads

H
  • Question
Mitel YSE
Replies
2
Views
511
Billz66
Billz66
Bill.2
  • Locked
  • Question
Mitel 6940 Connecting to Mitel connect director
Replies
0
Views
138
Bill.2
Bill.2
Asterixx
  • Locked
  • Question
mitel alarm
Replies
2
Views
419
The mitel guy
The mitel guy
bdvtech
  • Question
Mitel 470 dial out issue
Replies
7
Views
618
bdvtech
bdvtech
Rashadkim
  • Locked
  • Question
mitel 5000 mutlu calls
Replies
0
Views
81
Rashadkim
Rashadkim

Part and Inventory Search

Sponsor

Back
Top