Connect Magix w/ T1 to PBX in same room

[tecphonelady]

We have an application where we'd like to connect a Magix Rel 1.5 with a 100 DS1 card to a PBX in the same room.

The other PBX (a Rolm) has a RJ48 off the swith cable. Can we just put a cross over cable between the RJ48 and the DS1 card in the Magix?

What programming is necessary in the Magix to have this work as Tie lines?

Thanks!

 

[jinxs]

I'm not sure about the ROLM but the crossover pinouts for a magix to magix is as follows..

RJ45 1 RJ45 2
1-----------------------------------------5
2-----------------------------------------4
4-----------------------------------------2
5-----------------------------------------1

As far as assigning the magix as tie lines....After you program the framing..supression..ect..it's all under lines/trunks...ls/gs/ds1......type..T1....and then all tie.

After that..you tweak the tie lines under lines/trunks...tie lines...You can assign them wink/rotary..immediate/TT however you wish...type of Tie trunk...ect. All you need to do is match the ROLM. Should be simple enough.